Remote Commands
R&S
®
Cable Rider ZPH
479
User Manual 1321.0950.02 ─ 07
The trigger slope applies to all trigger sources.
Parameters:
<TriggerSlope>
POSitive | NEGative
*RST:
POSitive
Example:
TRIG:SLOP NEG
TRIGger[:SEQuence]:LEVel:IQPower
<IQPowerLevel>
This command defines the trigger level of the I/Q power trigger.
Prerequisites for this command: Select I/Q power trigger
TRIGger[:SEQuence]:
SOURce
on page 406.
Parameters:
<IQPowerLevel>
*RST:
-20
Default unit: dBm
Example:
TRIG:SOUR IQP
TRIG:LEV:IQP -10
Configure I/Q power trigger.
TRIGger[:SEQuence]:SOURce
<TriggerSource>
This command selects the trigger source.
Parameters:
<TriggerSource>
IMMediate | EXTernal | VIDeo | IQPower | GATed
IMMediate
Selects Free Run measurements.
EXTernal
Selects an external trigger.
VIDeo
Selects the video trigger.
IQPower
Selects an IQ Power trigger.
Gated
Selects a gated trigger.
*RST:
IMMediate
For more information, see chapter "Setting the Sweep".
Example:
TRIG:SOUR EXT
Selects the external trigger input as source of the trigger signal.
14.6.5.5
Setting the Marker
The following chapter describes command necessary to configure the markers.
Remote Control - Commands
