Remote Commands
R&S
®
Cable Rider ZPH
493
User Manual 1321.0950.02 ─ 07
●
Defining the Video Bandwidth
............................................................................... 496
●
Reading Out Measurement Results
......................................................................497
●
Selecting a Telecommunication Standard
.............................................................497
14.6.6.1
Setting the Frequency
The following chapter describes commands necessary to define frequency settings.
List of commands
[SENSe:]PMETer:FREQuency
.........................................................................................493
[SENSe:]PMETer:FREQuency
<Frequency>
This command sets the frequency of the power sensor.
Parameters:
<Frequency>
Specified in the data sheet.
Default unit: GHz
Example:
PMET:FREQ 500 MHZ
Sets the power sensor's frequency to 500 MHz.
14.6.6.2
Setting the Wavelength
The following chapter describes commands necessary to define the wavelength set-
tings for the operation of optic power sensor.
List of commands
[SENSe:]PMETer:WAVelength
......................................................................................... 493
[SENSe:]PMETer:WAVelength
<Wavelength>
This command sets the wavelength when the optical power sensor is connected.
See the respective optic power sensor specification for the supported wavelength.
Parameters:
<Wavelength>
Default unit: NM
Example:
PMET:WAV 1550 NM
Set wavelength as 1550 nm.
14.6.6.3
Configuring Power Level Readout
The following chapter describes commands that configure the power level readout.
Remote Control - Commands
