Spectrum Analyzer Mode
R&S
®
Cable Rider ZPH
176
User Manual 1321.0950.02 ─ 07
2. Select the "Meas Mode" softkey.
The R&S Cable Rider ZPH opens a submenu to select the measurement mode.
3. Select the "TDMA Power "menu item.
The R&S Cable Rider ZPH starts to measure the TDMA power.
Two vertical lines define the measurement range.
Figure 8-3: Screen layout for TDMA power measurements
1 = TDMA power measurements mode
2 = TDMA power
3 = Measurement standard
4 = Measurement time
5 = Measurement limits
6 = Trigger level
7 = Trigger delay
8 = Measurement time input entry
9 =
Parameter view
10 =
Configuration overview
11 = TDMA power measurement softkey
8.1.4.1
Selecting a Standard
For more information on selecting a standard, see
Chapter 8.1.3.1, "Selecting a Stan-
dard"
,
on page 173.
8.1.4.2
Setting the Burst Length
The burst length is the measurement time that the R&S Cable Rider ZPH used to per-
form the TDMA power measurement. The burst length can be equal or less than the
sweep time.
Performing Spectrum Measurements
