9. Add the two (left and right) values obtained by the measurements taken in Step 8 and then divide the total
by
2
. From this sum, subtract the sum of the number inscribed on the end of the drive pinion divided by
100
. (If there is no figure inscribed, use 0.) This is the pinion height adjustment value.
Differential pinion height
0.038 mm {0.0015 in} or less
SPACER TABLE
REAR BEARING ASSEMBLY NOTE
1. Assemble the spacer selected in the pinion height adjustment to the drive pinion.
2. Press the drive pinion into the rear bearing using the
SSTs
and a press.
NOTE:
When the values obtained by the measurements taken in Step 8, 9
are 0.06 mm {0.0024 in}, 0.04 mm {0.0016 in} and the tip surface of the
drive pinion value is 2, the formula is ((0.06+0.04)/2)-(2/100)=0.03.
Therefore, assemble a spacer 0.03 mm {0.0012} thicker than the
currently assembled one. The thickness settings are in increments of
0.015 mm {0.0006}, so choose one closest in thickness and install.
Identification mark
Thickness (mm {in})
Identification mark
Thickness (mm {in})
08
3.080 {0.1213}
29
3.290 {0.1295}
09
3.095 {0.1220}
30
3.305 {0.1301}
11
3.110 {0.1224}
32
3.320 {0.1307}
12
3.125 {0.1230}
33
3.335 {0.1313}
14
3.140 {0.1234}
35
3.350 {0.1319}
15
3.155 {0.1242}
36
3.365 {0.1325}
17
3.170 {0.1248}
38
3.380 {0.1331}
18
3.185 {0.1254}
39
3.395 {0.1337}
20
3.200 {0.1260}
41
3.410 {0.1343}
21
3.215 {0.1266}
42
3.425 {0.1348}
23
3.230 {0.1271}
44
3.440 {0.1354}
24
3.245 {0.1278}
45
3.455 {0.1360}
26
3.260 {0.1283}
47
3.470 {0.1366}
27
3.275 {0.1289}
-
-
NOTE:
Install the spacer with the chamfer on the gear side.
2007 Mazda MX-5 Miata Sport
2007 DRIVELINE/AXLES Differential - MX-5 Miata
Microsoft
Thursday, July 09, 2009 3:11:17 PM
Page 38
© 2005 Mitchell Repair Information Company, LLC.
