List of parameters
Parameters
1-79
© Siemens AG 2007 All Rights Reserved
SINAMICS S List Manual (LH1), 07/2007
Description:
Displays the setpoint for the DC link voltage.
Description:
Displays the actual phase voltage.
Index:
[0] = Phase U
[1] = Phase V
[2] = Phase W
Note:
The values are determined from the transistor power-on duration.
Description:
Setting to pre-assign/check the sampling times for the internal controller clock cycles for clock synchronous PROFI-
BUS operation.
p0092 = 1:
The controller clock cycles are set so that clock synchronous PROFIBUS operation is possible. If it is not possible
to change the controller clock cycles of the clock synchronous PROFIBUS operation, then an appropriate mes-
sage/signal is output.
The pre-setting of the controller clock cycles can result in a de-rating of the Motor Module (e.g. p0115[0] = 400 µs -
-> 375 µs).
p0092 = 0:
The controller clock cycles are set without any restrictions by the clock synchronous PROFIBUS operation (as for
up to version V2.3).
Dependency:
Refer to: r0110, p0115
Refer to: A01223, A01224
r0088
CO: DC-link voltage setpoint / Vdc setpoint
A_INF
Can be changed:
-
Calculated:
-
Access level:
3
Data type:
Floating Point
Dynamic index:
-
Func. diagram:
8940, 8964
P-Group:
Displays, signals
Units group:
5_2
Unit selection:
p0505
Not for motor type:
-
Expert list:
1
Min Max
Factory
setting
- [V]
- [V]
- [V]
r0089[0...2]
Actual phase voltage / U_phase act val
SERVO, VECTOR
Can be changed:
-
Calculated:
-
Access level:
3
Data type:
Floating Point
Dynamic index:
-
Func. diagram:
6719
P-Group:
Displays, signals
Units group:
5_3
Unit selection:
p0505
Not for motor type:
-
Expert list:
1
Min Max
Factory
setting
- [V]
- [V]
- [V]
p0092
Clock synchronous operation pre-assignment/check / Clock sync op
CU_S
Can be changed:
C1(1)
Calculated:
-
Access level:
1
Data type:
Integer16
Dynamic index:
-
Func. diagram:
-
P-Group:
-
Units group:
-
Unit selection:
-
Not for motor type:
-
Expert list:
1
Min Max
Factory
setting
0 1
0
