Myray hyperion X9, Operator'S Manual

Page: 43 / 1226

EN OPERATOR'S MANUAL
43
6. 3D TOMOGRAPHIC EXAMINATION (CB3D)
ONLY FOR 3D DEVICES
The CB3D examination is obtained by three-dimensional reconstruction of the anatomic region X-rayed and can be
consulted both through two-dimensional views and three-dimensional representations generated by a program run on
a workstation (PC).
Read the iRYS software user manual for the instructions for image processing.
Remember to change the single-use protections before positioning each new patient.
Before positioning the patient, make sure that the patient has taken off all metal objects, such as glasses,
removable prostheses, earrings and other removable metal objects at the height of the head. If a radiation
protection apron is used, make sure that the patient’s neck is not covered, otherwise there would be an area
not exposed to the X-ray.
6.1. SELECTING THE EXAMINATION FROM THE CONTROL CONSOLE
The 3D examination can only be performed if the X-ray device is connected to a PC with the iRYS software
installed.
1) Turn on the PC and run the iRYS program .
2) At the first start of the day, you are asked to complete the daily check procedure before being able to perform any
3D examination. The daily check procedure is a service procedure with emission of X-rays to be carried out
WITHOUT A PATIENT.
3) For the instructions, see “Acquisition operations” in the iRYS manual.
The patient does NOT need to access the X-ray device during the examination selection operations, but only
at the end of the procedures described in this paragraph.
View the FAVOURITES home page by tapping the HOME icon .
If the 3D examination is among the favourites, you can
select it by tapping the relative icon, otherwise access the
3D section after pressing EXAM.