Hitachi CHROMASTER 5160, Instruction Manual

Page: 940 / 1022

4.5 Error Messages
4.5.1 Autosampler Main Unit Errors
Table 4-3 Autosampler Main Unit Errors
No. Error Message Possible Cause Remedy
1 ROM ERROR
2 RAM ERROR
3 LOG_INFORMATION
ERROR
4 EEPROM ERROR
5 PARAMETER
ERROR
PC board malfunctions. Turn on power supply again.
If the same error is indicated
again, contact your nearest
service office of Hitachi High-
Technologies Corporation sales
representative.
6 COMMUNICATION
ERROR
Communication is abnormal. Check connection of the
communication cable, and
reconnect the autosampler with
the chromatography data station
(CDS).
7 CHECK VIAL NO. When starting analysis
(pressing the
START key),
vial numbers beyond the
maximum number of vials as
a rack parameter are set in a
sequential program.
8 CHECK START
STEP NO.
1. When starting analysis
(pressing the START key),
a start step No. which is
not contained in a
sequential program is set.
2. Setting of a start step No.
which is not contained in a
sequential program was
attempted by the UTILITY
function.
9 CHECK TOTAL VOL An injection volume that
cannot be handled with the
mounted syringe is set.
Check and correct the set
parameter value.
10 START KEY IS NOT
ACCEPTABLEDOOR
IS OPEN When starting analysis
(pressing the
START key),
the front doors (R)(L) of the
instrument are unclosed.
Close the front doors (R)(L) of the
instrument.
11 SYSTEM_BUSY:
CHECK OTHER
MODULE STATUS
When starting analysis
(pressing the
START key),
Other unit connected is in the
busy status.
Check status of other units and
release the busy status. (Stop of
liquid delivery with the pump,
setting of oven in condition before
heating ready status, etc.)
12 STOPPED BY
LEAKAGE
1. Solvent is leaking through
the flow path of
instrument.
2. Solvent remains in the
drain.
1. Wipe off leaked fluid
completely and retighten the
pipe joint.
2. Wipe off remaining solvent
completely.
4 - 19