Hitachi CHROMASTER 5160, Instruction Manual

Page: 862 / 1022

(a) Sequential parameter
The sequential parameter is settable in the following
procedure.
1 ENT
1 ENT
Input the start step (for start from a halfway step in a
sequential program).
NOTE
: The set value of start step will return to 1 once the
autosampler has been started by pressing the
START
key.
2 ENT
At the end of a sequential program, the ALL END signal can
be output. This signal is usable for control of other module
connected.
For output of the ALL END signal, input “1” (YES) or “0”
(NO) for avoiding the output.
0 ENT
UTILITY (SEQ=1, RACK=2, WASH PARAM=3,
1 OTHERS=4)
SEQ PARAM (START STEP=1, ALL END=2,
1
OPERATION=3, INJ TIMING=4)
START STEP (1-100)
1
Monitor screen reappears.
ALL END OUT (YES=1, NO=0)
1
Monitor screen reappears.
(to be continued)
3 - 18