Hitachi CHROMASTER 5160, Instruction Manual

Page: 800 / 1022

Needle
: Aspirates a sample.
Arm : Move right to left (X direction), back and forth (Y
direction), and up and down (Z direction).
Leak sensor : Detects fluid leakage.
Injection port : A port into which the needle is inserted to
inject a sample into the sample loop.
Sample loop : Stores samples.
External output terminal
Wiring cover
IFC board
Thermostat power supply
(Depends on the optional) Grounding terminal
WAIT OFF IN
START OUT
ALL END OUT
Fig. 2-4 Rear View
Wiring cover
: Removal of the left wiring cover (as
seen from the front) gives access to the
e-Line connector for connecting the
units of Chromaster series and the
power connector.
Grounding terminal : Grounds the autosampler.
Thermostat power supply (depend on the optional)
: Used for the optional thermostat.
IFC board (option) : An interface control board (option)
required for connecting the PC
(chromatography data station), the GUI
controller and HPLC system.
External input terminal : One input terminal and two output
terminals. Refer to the following table.
2 - 4