EXFO Power Blazer 88000 Series, User Manual

Page: 96 / 803

Selecting and Starting a Test
84
88000 Series
Intelligent Apps
3b. From the Network block, either select the basic test parameters
or click on
More
for all settings (refer to
Network Details (iSAM)
on page 226). The total bandwidth and the estimated test duration
are displayed.
3c. Select the remote operation mode; DTS is automatically selected
when the
RFC 6349 Test
is enabled:
3d. From the
Remote
block, either select the basic remote
parameters or click on More for all settings (refer to Remote
Details (iSAM)
on page 248).
Note: The iSAM test application uses Internal timing for clock synchronization.
4. Tap the
Start
button from the right navigation bar to start the test (refer
to Start/Stop|TX Button on page 657). If the connection with the
remote module is not established with either
DTS
or
Remote
Loopback mode, the automatic remote connection process is
performed before starting the test. The Summary result page will be
automatically displayed when the test is started from any Setup
configuration page. For additional results refer to
Test Results
on
page 341.
5. When the test ends automatically or is manually stopped, the generate
report pop-up is displayed by default. If required, tap
Yes to generate a
report of the test results and statistics (refer to Report Button on
page 647 for more information).
DTS (Dual Test Set)
The remote device is automatically set in EtherSAM when the
connection/overtake is successfully established.
Remote Loopback
The remote device is automatically set in Smart Loopback when the
connection/overtake is successfully established.
Manual Loopback
The remote device is a physical loopback or has to be manually set in
loopback.