EXFO Power Blazer 88000 Series, User Manual

Page: 93 / 803

Power Blazer
81
7 Selecting and Starting a Test
A test can be created either by selecting the test from the Test Applications
tab or by loading a previously saved configuration (refer to
Save/Load
Button on page 653 for more information).
Intelligent Apps
iOptics
To select, configure, and start iOptics:
1.
From the test menu, tap Setup .
2.
From the Test Applications tab, under Intelligent Apps , tap the
iOptics icon.
3.
From the Test Configurator tab select the interface/port and its rate.
3a. From the Optical Device Under Test block, tap the desired port
icon.
3b. Once the transceiver is correctly detected , select its rate.
3c.
From the Test Sequence block, select the test parameters and
thresholds (refer to Test Sequence (iOptics) on page 329).
Note:
The iOptics test application uses Internal timing for clock synchronization.
Test Sequence
Block Optical Device
Under Test Block