EXFO Power Blazer 88000 Series, User Manual

Page: 167 / 803

Test Setup - Test Configurator, Timer, and System
Power Blazer
155
EtherBERT, FC BERT, BERT (CPRI/OBSAI), and Unframed BERT
EtherBERT, FC BERT, BERT (CPRI/OBSAI), and
Unframed BERT
Note: For EtherBERT unframed test 40GE or 100GE, refer to BERT and Unframed
BERT
on page 139.
From the Test menu, tap Setup , Test Configurator and tap on the
EtherBERT
,
FC BERT
,
BERT
, or
Unframed BERT
block.
LINK
Note:
Available with OTN BERT test application with Ethernet client (EoOTN).
A green/red arrow is used to indicate the status of the link at the PCS level:

A green arrow indicates that the link is up.

A red arrow indicates alarms at the PCS level, the link is down.
The
Local Fault Detected
,
Local Fault Received
,
Remote Fault
,
LOA (OTU4), Hi-BER (OTU4), LOBL1027B (OTU3), Hi-BER1027B (OTU3),
and
LOAML1027B
(OTU3) alarms are displayed. Refer to
Ethernet
on
page 359, Ethernet - PCS Lanes on page 364, and Transcoding on page 405
for more information.
Restore < Test Application > Defaults
Reverts the current test application to its default factory settings.Only
available with OTN BERT test application with Ethernet client (EoOTN).
Pattern

Coupled RX to TX check box, when selected (default), couples both
the TX and RX signal with the same test pattern. The
Coupled RX to
TX check box is selected and not configurable for Seed A , Seed B , and
PRBS31 Unscrambled
patterns as well as for CPRI/OBSAI BERT test.