EXFO Power Blazer 88000 Series, User Manual

Page: 25 / 803

Getting Started
Power Blazer
13
Inserting and Removing Transceiver Adaptors (TA)
3. Remove the TA module from its
packaging:
3a.
Turn the retaining screw
counterclockwise until it is
loose.
3b. Hold the TA module by the
handle and/or the retaining
screw (NOT by the connectors)
and pull it out. Don‘t throw away the TA packaging, it is
recommended to insert the TA module into its packaging when
carrying the TA outside the FTBx-88260 module.
4. Insert the TA module into the FTBx-88260 module:
4a. Take the TA module and place it
so that the connector pins are at
the back as shown below.
The identification sticker and
the protruding edges are on the
left side.
4b.
Insert the protruding edges of
the module into the grooves of
the receptacle’s module port.
4c. Push the TA module all the way
to the back of the receptacle by
pressing firmly on the left edge
of the TA module until it is fully
inserted.
4d. Turn the retaining screw
clockwise until it is tightened.
This will secure the TA module
into its “seated” position.
Screw
Handle
Protruding edges
Grooves
Press on
the edge
Screw