EXFO Power Blazer 88000 Series, User Manual

Page: 349 / 803

Test Setup - Test Configurator, Timer, and System
Power Blazer
337
Traces (SONET/SDH)
Note: 16-bytes selection allows typing up to 15 bytes (a CRC-7 byte will be added
in front for a total of 16 bytes). 64-bytes selection allows typing up to
62-bytes (<C
R
> and <L
F
> bytes will be added at the end for a total of
64-bytes). Traces values should be ASCII suitable characters including the
ITU T.50 Characters on page 40.

TIM-S/RS-TIM
,
TIM-P/HP-TIM
,
TIM-V
/
LP-TIM
: Enables the
corresponding Trace Identifier Mismatch for the expected message
defined. These settings are coupled with the
Result - Traces/Labels
configuration (refer to Traces - SONET/SDH on page 527).
Format
: Allows the selection of the expected format:
16 Bytes (default), or 64 Bytes .
Expected
: Allows entering the expected J0 trace message for
TIM-S/RS-TIM, J1 for TIM-P/HP-TIM, and J2 for TIM-V/LP-TIM. See
Default values/messages
on page 336.
TCM Access Point Identifier
Note:
Available when TCM is enabled from the
Signal - Signal Configuration
(SONET/SDH) on page 307.

STS/AU Path (N1)
, and
VT/TU Path (Z6 or N1 (TU-3))
Enter the N1/Z6 value/message to be generated.

TC-TIM-P/HPTC-TIM/TC-TIM-V/LPTC-TIM
: Enables the corresponding
TCM Access Point Identifier for the expected message defined. These
settings are coupled with the Traces configuration from
Traces -
SONET/SDH on page 527.