EXFO Power Blazer 88000 Series, User Manual

Page: 270 / 803

Test Setup - Test Configurator, Timer, and System
258
88000 Series
RFC 2544 - Subtests
Back-to-Back
The objective of this test is to find the maximum number of frames that can
be sent at maximum throughput without frame loss. A burst of frames
(
Burst Time ) is sent with minimum inter-frame gaps to the device under
test and the number of forwarded frames is counted. If the count of
transmitted frames is equal to the number of forwarded frames, the length
of the burst is increased and the test is rerun. If the number of forwarded
frames is less than the number of transmitted frames, the length of the
burst is reduced and the test is rerun. The Back-to-Back value is the
number of frames in the longest burst that the Device Under Test (DUT)
can handle without the loss of any frames. The test performs the number of
defined trials (
Trials ). The Accuracy and Acceptable Errors settings
specify how precise that result must be. The test is performed for each
defined frame size.

Burst Time
is expressed in seconds:
1
(default) to
5
seconds.

Trials represents the number of times the Back-to-Back test will be
generated:
1
(default) to
100
trials.

Accuracy (Frames) is the accuracy measurement value in frames:
1
(default) to
50
frames.

Acceptable Errors represents the number of acceptable errors for the
test:
0
(default) to
10
.

Bursts represents the number of burst that will be generated:
1
(default) to
10
.