Suzuki Liana RH413, Service Manual

Page: 749 / 1302

Manual Transmission/Transaxle: 5B-40
5) Select pinion bearing shim No.2 as follows.
a) Place pinion bearings, spacer (2), shim(s) (1)
and drive gear (3) on bevel pinion dummy of
special tool (Bevel pinion dummy set) and
tighten new bevel pinion nut to specified torque
while holding drive gear (3) with special tool.
Tightening torque
Bevel pinion nut (a): 120 N·m (12.0 kgf-m,
87.0 lb-ft)
Special tool
(A): 09927–76030
(B): 09922–77270
b) Using torque wrench (1) and special tool,
measure preload.
Bevel pinion bearing preload
Standard: 0.5 – 1.3 N
⋅
m (5 – 13 kg-cm, 0.37–
0.94 lb-ft)
Special tool
(A): 09915–24550
NOTE
• Apply thin coat of gear oil to bearing
before measurement.
• Also before measuring preload, turn taper
bearing a few times to ensure its good
fitting.
c) Place bevel pinion adjuster on surface plate as
shown and set dial gauge (1) to “0”.
Special tool
(A): 09922–77270
NOTE
As bearing size is different between right and
left, use shim supplied in bevel pinion
dummy set under smaller size bearing as
shown.
d) Measure dimension “b” in figure by reading dial
gauge.
Special tool
(A): 09922–77270
e) Using the following table, select necessary
shim(s).
2. Box (30 mm)
I3RH0A520053-01
I3RH0A520054-01
[A]: Left side (Differential side bearing retainer)
[B]: Right side (Engine)
1. Drive pinion spacer
2. Pinion bearing shim No.1
I3RH0A520055-01
I3RH0A520056-01