Suzuki Liana RH413, Service Manual

Page: 748 / 1302

5B-39 Manual Transmission/Transaxle:
10) Using special tool, remove output flange (1).
Special tool
(A): 09913–60910
11) Using plastic hammer (1), drive out output shaft (2)
with bearings.
12) Remove oil seal (1) by using special tool, if
necessary.
Special tool
(A): 09913–50121
Assembly
1) If oil seal is removed, install new oil seal (1) by using
special tool. Apply grease to oil seal lip.
“A”: Grease 99000–25010
Special tool
(A): 09913–75810
Clearance
“a”: 1.0 – 1.5 mm (0.04 – 0.06 in.)
2) Install output flange (1), washer and new nut.
3) Tighten nut to specified torque by using special tool
and then caulk nut.
Special tool
(A): 09930–40113
Tightening torque
Transfer output flange nut (a): 90 N·m (9.0 kgf-
m, 65.0 lb-ft)
4) Press-fit bevel pinion bearing outer races (1) into
rear case (2) by using special tools.
Special tool
(A): 09924–74510
(B): 09951–16090
I3RH0A520037-01
2
1
I3RH0A520039-01
1
(A)
I3RH01332020-01
2. Output case
I3RH0A520047-01
I3RH0A520048-01
I3RH0A520052-01