Suzuki Liana RH413, Service Manual

Page: 355 / 1302

Front Suspension: 2B-13
• Tighten strut bracket nuts (3) to specified torque.
Tightening torque
Strut bracket nut (For 8.8 strength bolt) (b): 105
N·m (10.5 kgf-m, 76.0 lb-ft)
Strut bracket nut (For 12.9 strength bolt) (c): 90
N·m (9.0 kgf-m, 65.0 lb-ft)
NOTE
• Nut (for 12.9 strength bolt) is pre-coated
with friction stabilizer and provided with
marks indicating the strength class. Never
reuse this nut to prevent it from loosening.
Be sure to replace nut with a new one
whenever loosening once.
• Be sure to use a bolt and nut in the right
combination which is specified.
• Install ABS wheel speed sensor (1) (if equipped with
ABS).
Tightening torque
ABS wheel speed sensor mounting bolt (a): 23
N·m (2.3 kgf-m, 17.0 lb-ft)
• Connect tie-rod end (1) to steering knuckle (2).
Tighten castle nut (3) until holes for split pin (4) are
aligned, but only within specified torque.
Tightening torque
Tie-rod end castle nut (a): 45 N·m (4.5 kgf-m, 32.5
lb-ft)
• Install new split pin (4).
• Install brake caliper (3).
• Tighten caliper carrier bolt to specified torque.
Tightening torque
Caliper carrier bolt: 85 N·m (8.5 kgf-m, 61.5 lb-ft)
• Depress foot brake pedal and hold it there.
Tighten new drive shaft nut (1) to specified torque.
Tightening torque
Drive shaft nut (a): 175 N·m (17.5 kgf-m, 127.0 lb-
ft)
CAUTION
!
Never reuse drive shaft nut (1).
• Caulk drive shaft nut (1) as shown.
CAUTION
!
Be careful while caulking nut so that no crack
will occur in caulked part of nut. Cracked nut
must be replaced with new one.
• Tightening wheel nut to specified torque.
Tightening torque
Wheel nut: 85 N·m (8.5 kgf-m, 61.5 lb-ft)
F: Forward [A]: 8.8 strength bolt & nut
R: Rearward [B]: 12.9 strength bolt & nut
I3RH0A220013-01
I2RH01220043-01
I2RH01220044-01
I3RH01220002-01