Suzuki Liana RH413, Service Manual

Page: 383 / 1302

Rear Suspension: 2C-19
5) Install brake drum (1). Refer to “Rear Brake Drum
Removal and Installation in Section 4C”.
6) Pull up parking brake lever fully and tighten new
drive shaft nut (2) to specified torque.
Tightening torque
Rear drive shaft nut (a): 175 N·m (17.5 kgf-m,
126.5 lb-ft)
7) Caulk (3) drive shaft nut (2).
WARNING
!
Be careful while calking nut so that no crack
will occur in calked part of nut. Cracked nut
must be replaced with new one.
8) Install wheel and tighten wheel nut to specified
torque.
Tightening torque
Wheel nut: 85 N·m (8.5 kgf-m, 61.5 lb-ft)
9) Perform brake test.
Rear Wheel Hub, Wheel Bearing and Wheel
Stud Inspection
S3RH0A2306020
• Wheel bearing (2) and wheel hub (1) form a solid unit.
(for 2WD model)
• When wheel bearing is found defective and its
replacement is necessary, replace hub assembly. (for
2WD model)
Rear Wheel Disc, Nut and Bearing Check
S3RH0A2306021
• Inspect each wheel disc for dents, distortion and
cracks.
A disc in badly damaged condition must be replaced.
• Check wheel nuts for tightness and, as necessary,
retighten to specification.
Tightening torque
Wheel nut (a): 85 N·m (8.5 kgf-m, 61.5 lb-ft)
• Check wheel bearings for wear. When measuring
thrust play, apply a dial gauge to spindle cap center. If
thrust play exceeds limit, replace bearing.
Thrust play limit
“a”: 0.1 mm (0.004 in.)
• By rotating wheel actually, check wheel bearing for
noise and smooth rotation. If it is defective, replace
bearing.
I3RH01232016-01
I2RH01230044-01
I2RH01230010-01
I2RH01230011-01
I2RH01230012-01