Suzuki Liana RH413, Service Manual

Page: 296 / 1302

1G-12 Fuel System:
WARNING
!
A small amount of fuel may be released after
the fuel hose is disconnected. In order to
reduce the chance of personal injury, cover
the hose and pipe to be disconnected with a
shop cloth. Be sure to put that cloth in an
approved container when disconnection is
completed.
12) Support fuel tank (1) with jack (2) and remove its
mounting bolts.
13) Lower fuel tank a little to disconnect wire harness at
connector (1) and ground wire harness, then remove
fuel tank.
Installation
1) If parts have been removed from fuel tank, install
them before installing fuel tank to vehicle.
2) Raise fuel tank (1) with jack and connect fuel pump
connector and ground wire harness and clamp wire
harness.
3) Install fuel tank to vehicle.
Tightening torque
Fuel tank bolt (a): 50 N·m (5.0 kgf-m, 36.5 lb-ft)
4) Connect fuel filler hose (1) and breather hose (2) to
filler neck as shown in the figure and clamp them
securely.
Tightening torque
Fuel filler hose clamp (a): 1.5 N·m (0.15 kgf-m,
1.0 lb-ft)
5) Connect fuel feed pipe (1), fuel return pipe (3) and
purge pipe (2) to each pipe as shown in the figure
and clamp them securely.
CAUTION
!
• When connecting joint, clean outside
surfaces of pipe where joint is to be
inserted, push joint into pipe till joint lock
clicks and check to ensure that pipes are
connected securely, or fuel leak may
occur.
• Never let the fuel hoses touch the ABS
sensor harness (if equipped).
2
1
I3RH0A170004-01
2
1
I2RH0B170021-01
I2RH0B170022-01
(a)
1
I2RH0B170023-01
1
2
3
(a)
I2RH0B170024-01