Suzuki Liana RH413, Service Manual

Page: 267 / 1302

Engine Lubrication System: 1E-4
4) For 4WD vehicle, remove clutch housing (torque
converter housing for A/T vehicle) lower plate (1).
5) For 2WD vehicle, remove transaxle stiffener
referring to “Manual Transaxle Unit Dismounting and
Remounting in Section 5B” or “Automatic Transaxle
Unit Dismounting and Remounting in Section 5A”.
6) For 4WD vehicle, remove transfer referring to
“Transfer Dismounting and Remounting in Section
3C”.
7) Remove oil pan bolts and nuts.
8) Cut sealant at hatched part shown in figure using
special tool and hammer (1).
Special tool
(A): 09921–96510
NOTE
Be careful not to damage stud bolt (3)
between oil pan and cylinder block when
cutting sealant.
9) Remove oil pan (2) from cylinder block.
10) Remove oil pump strainer (1) from cylinder block.
Installation
1) Apply sealant to oil pan mating surface continuously
as shown in the figure.
“A”: Water tight sealant 99000–31250
Sealant amount for oil pan
Width “a”: 3 mm (0.12 in.)
Height “b”: 2 mm (0.08 in.)
2) Install new O-rings (2) in the position as shown in the
figure and install oil pump strainer (1).
Tighten strainer bolt (3) first and then bracket bolt (4)
to specified torque.
Tightening torque
Oil pump strainer bolt (a): 11 N·m (1.1 kgf-m, 8.0
lb-ft)
Oil pump strainer bracket bolt (b): 11 N·m (1.1
kgf-m, 8.0 lb-ft)
1
I2RH0B150009-01
I3RH0A150002-01
I2RH0B150010-01
I2RH0B150011-01
I2RH0B150012-01