Suzuki Liana RH413, Service Manual

Page: 805 / 1302

Power Assisted Steering System: 6C-14
• For installing each part, refer to respective procedures as indicated in the following.
• After installation, be sure to fill specified power steering fluid and bleed air.
• Check toe setting. Adjust as required. Refer to “Front Wheel Alignment Inspection and Adjustment in Section 2B”.
Steering Rack Boot On-Vehicle Inspection
S3RH0A6306006
Check boot for any crack and damage which, means
there is some possibility of rusty gear, entry of dust or
lack of grease. Also, check if any of such faulty
conditions exists.
Tie-Rod / Rack Boot Removal and Installation
S3RH0A6306013
Removal
1) Remove steering gear box from vehicle referring to
“P/S Gear Box Removal and Installation”.
2) For ease of adjustment after installation, make
marking (4) of tie-rod end lock nut position of tie-rod
thread.
3) Loosen tie-rod end lock nut (2) and remove tie-rod
end.
4) Remove boot wire and clip.
5) Remove boot (3) from tie-rod (1).
6) Unbend three bent portions (1) of tie-rod lock
washer, and then remove tie-rod (2) from rack (3).
Model Part Section
2WD
Exhaust pipe No.2 “Exhaust Pipe Removal and Installation in Section 1K”
Mounting member “Front Suspension Frame Removal and Installation in Section 2B”
Engine rear mounting bracket “Front Suspension Frame Removal and Installation in Section 2B”
4WD
Drive shaft “Front Drive Shaft Assembly Removal and Installation in Section 3A”
Exhaust No. 1 and No. 2 pipe “Exhaust Pipe Removal and Installation in Section 1K”
Suspension control arm ball stud “Front Suspension Frame Removal and Installation in Section 2B”
Engine rear mounting nut
“Front Suspension Frame Removal and Installation in Section 2B”
Suspension frame “Front Suspension Frame Removal and Installation in Section 2B”
Transfer stiffener “Transfer Dismounting and Remounting in Section 3C”
Transfer assembly “Transfer Dismounting and Remounting in Section 3C”
I2RH01630012-01
I2RH01630030-01
4. Aluminum plate
5. Vise
I3RH0A630004-01