Suzuki Liana RH413, Service Manual

Page: 837 / 1302

Heater and Ventilation: 7A-19
6) Connect connector to temperature control actuator.
7) Set temperature selector of HVAC control module to
MAX COOL position with ignition switch ON, and
make sure if the position of actuator lever is MAX
COOL position (B).
8) Turn ignition switch OFF, and then disconnect
connector from temperature control actuator.
9) Measure resistance between terminal “1” and “3”.
Temperature control actuator resistance between
terminal “1” and “3” (MAX COOL position)
Approximately 1.2 k
Ω
If check result is not satisfactory, replace the actuator
with new one.
Air Flow Control Actuator Removal and
Installation
S3RH0A7106018
Removal
1) Set air flow selector to DEF position.
2) Disconnect negative cable at battery.
3) Disconnect connector (2).
4) Remove air flow control actuator (1) from heater unit,
and then detach air flow actuator rod from clip on
linkage (3).
Installation
1) Install air flow control actuator on heater unit, and
then connect connector to air flow control actuator.
2) Set air flow selector to DEF position with ignition on.
3) Set position of air flow selector linkage (1) to DEF
position by rotating the linkage to the arrow direction
till it stops.
4) Engage air flow control actuator rod (2) with the clip
(3).
Air Flow Control Actuator Inspection
S3RH0A7106019
1) Remove air flow control actuator from heater unit
referring to “Air Flow Control Actuator Removal and
Installation”.
2) Connect actuator connector to the actuator (1).
B
5 4 3 2 1
4
5
3
2
1
I3RH0A710024-01
1
2
3
I4RH01722046-01
I4RH01722047-01
1
2
3
I3RH0A710016-01
1
I4RH01722049-01