Suzuki Liana RH413, Service Manual

Page: 405 / 1302

Drive Shaft / Axle: Front 3A-6
4) Draw away cage (1) by using bearing puller (2), and
remove boot (3) from shaft.
5) Remove differential side boot small band, and then
pull out differential side boot from shaft.
6) Pull out damper through shaft, if equipped.
7) Remove boot bands of wheel side joint boot, and
then pull out boot through shaft.
CAUTION
!
Do not disassemble wheel side joint. If any
malcondition is found, replace it as
assembly.
For center shaft and center bearing support
1) Using hydraulic press (1), draw out center shaft (2)
from center bearing (3).
2) Remove bearing support circlip (1).
Special tool
(A): 09900-06108
3) Remove center bearing from center bearing support.
Assembly
For tripod joint type
Judging from abnormality noted before disassembly and
what is found through visual check of component parts
after disassembly, prepare replacing parts and proceed
to reassembly.
Make sure that wheel side joint assembly (1) and tripod
joint housing (2) are washed thoroughly and air dried.
Replace boot(s) (3) with new one(s).
CAUTION
!
• Do not wash boots in degreaser such as
gasoline or kerosene. etc. Washing in
degreaser causes deterioration of boot.
• To ensure full performance of joint as
designed, be sure to distinguish between
two types of grease in repair set and apply
specified volume to respective joint
referring to the followings for identification
of the grease.
Grease color
“A”: Black
“B”: Orange
Amount
“A”: 45 – 65 g (1.6 – 2.3 oz)
“B”: 90 – 110 g (3.2 – 3.9 oz) for right side of 4WD
model
“B”: 110 – 120 g (3.5 – 4.2 oz) for 2WD model and left
side of 4WD model
I2RH01310014-01
IYSY01311021-01
I3RH0A311005-01
[A]: Wheel side
[B]: Differential side
I3RH0A311010-01