Suzuki Liana RH413, Service Manual

Page: 403 / 1302

Drive Shaft / Axle: Front 3A-4
11) Remove drive shaft assembly.
CAUTION
!
To prevent damage of boots, be careful not to
bring them into contact with other parts,
when removing drive shaft assembly.
12) [For vehicle with center shaft]
Remove center shaft support bolts (3) and remove
center shaft support (2) with center shaft (1) from
differential side gear.
Installation
CAUTION
!
• To avoid excessive expansion of boot and
consequential disconnection of joint in
boot, do not pull differential side joint
housing.
• Protect boots from any damage,
preventing them from unnecessary contact
while installing drive shaft.
• Do not hit joint boot with hammer.
Inserting joint only by hands is allowed.
• Make sure that differential side joint is
inserted fully and its snap ring is seated as
it was.
• Do not damage oil seal when installing and
removing center shaft.
Install drive shaft assembly by reversing removal
procedure and noting the following points.
• Do not reuse drive shaft nut (2).
• Do not reuse split pin (1).
• Tighten each bolt and nut to the specified torque.
Tightening torque
Ball stud bolt (b): 60 N·m (6.0 kgf-m, 43.5 lb-ft)
Tie-rod end castle nut (c): 45 N·m (4.5 kgf-m, 32.5
lb-ft)
Drive shaft nut (d): 175 N·m (17.5 kgf-m, 127.0 lb-
ft)
Wheel nut (e): 85 N·m (8.5 kgf-m, 61.5 lb-ft)
Center bearing support bolt (a): 55 N·m (5.5 kgf-
m, 40.0 lb-ft)
• Fill transaxle with oil referring to “Manual Transaxle
Oil Change in Section 5B” for M/T model, “A/T Fluid
Change in Section 5A” for A/T model.
• Fill transfer with oil referring to “Transfer Oil Change in
Section 3C” for 4WD model.
Front Drive Shaft Disassembly and Assembly
S3RH0A3116003
Disassembly
For tripod joint type
1) Remove differential side boot big band, and then
take out joint housing (1).
3
2
1
I2RH01310007-01
I3RH0A311003-01
I2RH01310008-01