Suzuki Liana RH413, Service Manual

Page: 283 / 1302

Engine Cooling System: 1F-12
4) Loosen water pump / generator drive belt adjusting
bolt (2) and generator pivot bolt (3). Then remove
water pump / generator drive belt (1) and water
pump pulley. Refer to “Water Pump / Generator
Drive Belt Removal and Installation”.
5) Remove water pump assembly (1).
Installation
1) Apply sealant (1) to mating surface of water pump as
shown in the figure.
“A”: Water tight sealant 99000–31250
Sealant quantity (to mating surface of water
pump)
Width “a”: 3 mm (0.12 in.)
Height “b”: 2 mm (0.08 in.)
2) Install water pump assembly (1) to cylinder block
and tighten bolts and nut to specified torque.
Tightening torque
Water pump bolt and nut (a): 22 N·m (2.2 kgf-m,
16.0 lb-ft)
3) Install water pump pulley.
4) Install water pump / generator drive belt referring to
“Water Pump / Generator Drive Belt Removal and
Installation”.
5) Install A/C compressor belt referring to “Compressor
Drive Belt Removal and Installation in Section 7B” (if
equipped).
6) Fill coolant referring to “Cooling System Flush and
Refill”.
7) Connect negative cable at battery.
8) Check each part for leakage.
Water Pump Inspection
S3RH0A1606015
CAUTION
!
Do not disassemble water pump.
If any repair is required on pump, replace it
as assembly.
• Rotate water pump by hand to check for smooth
operation. If pump does not rotate smoothly or makes
abnormal noise, replace it.
2
3
1
I2RH0B160014-01
I2RH0B160016-01
I2RH0B160017-01
I2RH0B160018-01
I2RH0B160019-01