Engine General Information and Diagnosis: 1A-26
U
*
O2S B1 S2 (HEATED
OXYGEN SENSOR-2)
When engine is running at 2000 r/min. for 3 min.
or longer after warming up.
0 – 0.95 V
DESIRED IDLE (DESIRED
IDLE SPEED)
At idling with radiator cooling fan stopped and all
electrical parts turned OFF after warming up, M/
T at neutral, A/T at “P” range
1.3 L M/T: 700 r/min.
1.6 L M/T: 660 r/min.
1.6 L A/T: 700 r/min.
TP SENSOR VOLT
(THROTTLE POSITION
SENSOR OUTPUT
VOLTAGE)
Ignition switch ON /
engine stopped
Throttle valve fully closed
More than 0.2 V
Throttle valve fully open
Less than 4.8 V
INJ PULSE WIDTH (FUEL
INJECTION PULSE WIDTH)
At specified idle speed with no load after
warming up
2.0 – 4.0 msec.
At 2500 r/min. with no load after warming up
2.0 – 3.6 msec.
IAC FLOW DUTY (IDLE AIR
CONTROL FLOW DUTY)
At idling with no load after warming up
5 – 25%
TOTAL FUEL TRIM B1
At specified idle speed after warming up
–35 – +35%
BATTERY VOLTAGE
Ignition switch ON / engine stop
10 – 14 V
CANIST PRG DUTY (EVAP
CANISTER PURGE FLOW
DUTY)
—
0 – 100%
CLOSED THROT POS
(CLOSED THROTTLE
POSITION)
Throttle valve at idle position
ON
Throttle valve opens larger than idle position
OFF
FUEL CUT
When engine is at fuel cut condition
ON
Other than fuel cut condition
OFF
RADIATOR FAN
(RADIATOR FAN CONTROL
RELAY)
Ignition switch ON Engine coolant temp.:
Lower than 95
°
C (203
°
F)
OFF
Engine coolant temp.: 97.5
°
C (208
°
F) or higher
ON
ELECTRIC LOAD
Ignition switch ON / Headlight, small light and
rear window defogger all turned OFF
OFF
Ignition switch ON / Headlight, small light or rear
window defogger turned ON
ON
A/C SWITCH
Ignition switch
turned ON
A/C switch and blower
motor switch turned ON
ON
A/C switch and/or blower
motor switch turned OFF
OFF
PNP SIGNAL (PARK/
NEUTRAL POSITION
SIGNAL) A/T only
Ignition switch ON Selector lever in “P” or “N”
position
P/N Range
Selector lever in “R”, “D”,
“2” or “L” position
D Range
STEP EGR FLOW DUTY
At specified idle speed after warming up
0%
U
FUEL TANK LEVEL
—
0 – 100%
BAROMETRIC PRESS
—
Display the barometric
pressure
FUEL PUMP
Within 3 seconds after ignition switch ON or
engine running
ON
Engine stop at ignition switch ON.
OFF
BRAKE SW
Ignition switch ON Brake pedal is depressing
ON
Brake pedal is releasing
OFF
Scan tool data
Vehicle condition
Normal condition /
reference values
Summary of Contents for Liana RH413
