Suzuki Liana RH413, Service Manual

Page: 766 / 1302

5C-5 Clutch:
Clutch Fluid Pipe and Hose Removal and
Installation
S3RH0A5306005
Removal
CAUTION
!
Do not allow fluid to get on painted surface. It
may cause painted surface damage.
1) Remove dust and dirt from each joint of hose and
pipe to be disconnected and clean around reservoir
cap.
2) Take out fluid with syringe or such.
3) Disconnect fluid pipe from hose.
NOTE
To disconnect pipe (1) from hose (2),
separate them by using flare nut wrench (4)
and spanner (3) so as not to kink them.
Installation
Reverse removal procedure for installation noting the
following.
CAUTION
!
• Do not allow fluid to get on painted
surface.
• Do not allow pipe and hose to contact hard
against vehicle body or other parts.
• For air bleeding of master cylinder alone, it must be
removed from vehicle body.
(For procedures of removal and installation of master
cylinder and air bleeding, refer to “Clutch Master
Cylinder Removal and Installation”.)
• Install each clamp securely.
• For installation angle of each hose, refer to “Clutch
Fluid Pipe and Hose Components”.
• Install E-ring (1) securely as shown.
Tightening torque
Clutch pipe flare nut (a): 16 N·m (1.6 kgf-m, 11.5
lb-ft)
• After installation, check clutch pedal free travel and
bleed air from system referring to “Clutch Pedal
Inspection” and “Air Bleeding of Brake System in
Section 4A”.
• Check fluid leakage.
• Add fluid to MAX level of reservoir.
Clutch Fluid Pipe and Hose Inspection
S3RH0A5306006
Check pipe (1) and hose (2) for dent, kink, crack, dirt and
dust. Replace if check result is not satisfactory.
I2RH01530005-01
2. Hose
3. Pipe
I2RH01530006-01
I2RH01530007-01