Suzuki Liana RH413, Service Manual

Page: 757 / 1302

Manual Transmission/Transaxle: 5B-48
Defect in
parts
When tooth contacts occur as shown at the left, proper
rear case offset (18 mm) in not obtained.
Correction:
Replace rear case (rear case, right case and left case
assembly).
When tooth contacts are deviated toward inside or
outside of gear, possible causes are as follows.
• Drive bevel gear or drive bevel pinion defective.
• Poor squareness of rear case.
• Rear case surface where gear is installed is defective.
Correction:
Replace defective part as an assembly.
When tooth contacts occur as shown at the left, gear
itself is defective.
Correction:
Replace drive bevel gear and drive bevel pinion as a set.
When contact is not oval in shape, gear itself is defective.
Abnormal contact is also caused by nick in tooth surface
or faulty condition of differential case at its drive bevel
gear mounting part.
Correction:
Replace drive bevel gear and drive bevel pinion as a set
and differential gear case as well, if found defective.
Tooth surface contact Possible cause and correction
I3RH0A520076-01
I3RH0A520077-01
I3RH0A520078-01
I3RH0A520002-01