Suzuki Liana RH413, Service Manual

Page: 1246 / 1302

9J-7 Hood / Fenders / Doors:
Rearend Door Assembly (for Wagon Model)
Removal and Installation
S3RH0A9A06010
Removal
1) Remove rearend door trim.
2) Remove related section of head lining and quarter
trim.
3) Disconnect rearend door harness couplers (1) and
washer hose (2).
4) Remove rearend door balancers (3).
5) Remove door hinge nuts (4) and remove rearend
door assembly (5).
WARNING
!
Handling of Rearend Door Balancer (Damper)
• Handle balancer carefully. Do not scar or
scratch exposed surface of its piston rod,
and never allow any paint or oil to stick to
its surface.
• Do not turn piston rod with balancer fully
extended.
• Do not disassemble balancer (1) because
its cylinder is filled with gas.
Discarding of Rearend Door Balancer
(Damper)
• The gas itself in balancer is harmless but it
may issue out of the hole together with
chips generated by the drill (2). Therefore,
be sure to wear goggle when drilling.
• Using a 2 to 3 mm (0.08 to 0.12 in.) drill (2),
make a hole to remove gas inside as
shown before discarding.
Installation
Reverse removal procedure noting the following.
• Secure wiring harness.
• Adjust door latch striker position by referring to
“Rearend Door Lock Assembly (for Wagon Model)
Removal and Installation in Section 9F”.
• Adjust door cushion so that door contacts body when
closed.
• Apply sealant to contact face “A” of door hinge (1) and
apply grease to rotating part “B” of hinge (1).
Specified sealant and grease.
“A”: Sealant 99000–31110
“B”: Grease 99000–25010
3
2
4
1
3
5
I2RH019A0009-01
I2RH019A0010-01
I2RH019A1011-01
I2RH019A1012-01