Suzuki Liana RH413, Service Manual

Page: 1198 / 1302

9E-7 Glass / Windows / Mirrors:
12) Check for water leakage by pouring water over
windshield through hose. If leakage is found, dry
windshield and fill leaky point with adhesive. If water
still leaks even after that, remove glass and start
installation procedure all over again.
NOTE
• Do not use high pressure water.
• Do not blow compressed air directly at
adhesive applied part when drying.
• Do not use infrared lamp or like for drying.
CAUTION
!
Upon completion of installation, note the
following.
• Sudden closing of door before adhesive is
completely set may cause glass to become
loose or to come off. Therefore, if door is
opened or closed before adhesive is
completely set, make sure to open all door
glasses and use proper care.
• If molding is not securely in place, hold it
down with a tape until adhesive is
completely set.
• Each adhesive has its own setting time.
• Be sure to refer to its maker’s instruction,
check setting time of adhesive to be used
and observe precautions to be taken
before adhesive is set.
• Refrain from driving till adhesive is
completely set so as to ensure proper and
sufficient adhesion.
Front Pillar Window Removal and Installation
S3RH0A9506002
Refer to “Windshield Removal and Installation” as removal and installation procedures are basically the same.
However, note the following.
• Observe the following precautions when applying adhesive (1) along glass (2) edge.
• Adhesive (1) should be applied evenly especially in height.
• Be careful not to damage primer (3).
• Press glass against body quickly after adhesive (1) is applied.
Adhesive amount specification and position for front pillar window
Height “a”: 10 mm (0.39 in.)
Width “b”: 6 mm (0.24 in.)
Position “c”: 4.5 mm (0.18 in.)
Width “d”: 12 mm (0.47 in.)
I2RH01950051-01
I4RH01950005-01
4. Molding
5. Side body outer panel