Suzuki Liana RH413, Service Manual

Page: 219 / 1302

Engine Mechanical: 1D-14
6) Remove water pump belt.
7) Drain engine oil, transaxle oil or A/T fluid (for A/T
vehicle) and transfer oil (for 4WD vehicle).
8) Drain coolant referring to “Cooling System Flush and
Refill in Section 1F”.
9) Remove air cleaner case and hoses.
10) With hose connected, detach A/C compressor and/
or P/S pump from its bracket (if equipped).
NOTE
Suspend removed A/C compressor and/or P/
S pump at a place where no damage will be
caused during removal and installation of
engine assembly.
11) Disconnect the following electric wires:
12) Remove fuse box from its bracket.
13) Disconnect the following cables.
• Accelerator cable
• Gear select control cable (For M/T vehicle)
• Gear shift control cable (For M/T vehicle)
• Gear select cable (15) (For A/T vehicle)
TP sensor (1) Generator (8)
MAP sensor (2) Starting motor
ECT sensor Magnet clutch switch of A/C
compressor (if equipped)
CMP sensor Ground terminal (9) from intake
manifold and cylinder block
CKP sensor VSS
Knock sensor Back up light switch (For M/T
vehicle)
Heated oxygen
sensor Shift switch (10) (For A/T
vehicle)
EGR valve (3) A/T VSS (11) (For A/T vehicle)
IAC valve (4) NC1 sensor (12)
EVAP canister purge
valve (5) A/T shift solenoid (13) (For A/T
vehicle)
Injectors (6) Speedometer sensor
Ignition coil assembly
(7) Battery ground cable (14) from
transaxle
Engine oil pressure
switch Each wire harness clamps
I2RH0B140025-01
I2RH0B140041-01