Suzuki Liana RH413, Service Manual

Page: 37 / 1302

Maintenance and Lubrication: 0B-5
4) Screw new filter on oil filter stand by hand until the
filter O-ring contacts mounting surface.
CAUTION
!
To tighten oil filter properly, it is important to
accurately identify the position at which filter
O-ring first contacts mounting surface.
5) Tighten the filter (1) 3/4 turn from the point of contact
with the mounting surface using an oil filter wrench
(2).
Tightening torque
Oil filter (b): 14 N·m (1.4 kgf-m, 10.5 lb-ft) for
reference
6) Replenish oil until oil level is brought to FULL level
mark on dipstick (oil pan and oil filter capacity). The
filler inlet is at the top of the cylinder head cover. It is
recommended to use engine oil of SG, SH, SJ or SL
grade. Select the appropriate oil viscosity according
to the proper engine oil viscosity chart [A].
NOTE
Engine oil capacity is specified as the
following.
However, note that the amount of oil required
when actually changing oil may somewhat
differ from the data depending on various
conditions (temperature, viscosity, etc.).
Engine oil specification
Oil pan capacity: About 3.6 liters (7.6 / 6.3 US /
lmp pt.)
Oil filter capacity: About 0.2 liter (0.4 / 0.3 US /
lmp pt.)
Others: About 0.3 liter (0.6 / 0.5 US / lmp pt.)
Total: About 4.1 liters (8.7 / 7.2 US / lmp pt.)
7) Check oil filter and drain plug for oil leakage.
8) Start engine and run it for three minutes. Stop it and
wait another 5 minutes before checking oil level. Add
oil, as necessary, to bring oil level to FULL level
mark on dipstick.
Engine Coolant Change
S3RH0A0206004
WARNING
!
To avoid danger of being burned, do not
remove radiator cap while engine and
radiator are still hot. Scalding fluid and steam
can be blown out under pressure if cap is
taken off too soon.
Change engine coolant referring to “Cooling System
Flush and Refill in Section 1F”.
Exhaust System Inspection
S3RH0A0206005
WARNING
!
To avoid danger of being burned, do not
touch exhaust system when it is still hot.
Any service on exhaust system should be
performed when it is cool.
When carrying out periodic maintenance or vehicle is
raised for other service, check exhaust system as
follows:
• Check rubber mountings for damage and
deterioration.
• Check exhaust system for leakage, loose
connections, dents and damages.
If bolts or nuts are loose, tighten them to specification.
Refer to “Exhaust System Components in Section 1K”
for torque specification of bolts and nuts.
• Check nearby body areas for damaged, missing or
mispositioned parts, open seams, holes, loose
connections or other defects which could permit
exhaust fumes to seep into the vehicle.
• Make sure that exhaust system components have
enough clearance from the underbody to avoid
overheating and possible damage to floor carpet.
• Any defects should be fixed at once.
IYSQ01020010-01
I2RH0B020006-01
1. Full level mark (hole)
2. Low level mark (hole)
IYSQ01020012-01