Suzuki Liana RH413, Service Manual

Page: 783 / 1302

Steering Wheel and Column: 6B-4
4) Make alignment marks (1) on steering wheel and
shaft for a guide during reinstallation.
CAUTION
!
Do not hammer the end of the shaft.
Hammering it will loosen the plastic shear
pins which maintain the column length and
impair the collapsible design of the column.
5) Remove steering wheel (1) with special tool.
Special tool
(A): 09944-36011
Installation
1) Install new steering wheel lower cover to steering
wheel as follows if necessary.
a) Install steering wheel lower cover (1) to steering
wheel (2), and tighten steering wheel lower cover
screws (3) as specified torque.
Tightening torque
Steering wheel lower cover screw (a): 0.85
N·m (0.085 kgf-m, 0.6 lb-ft)
b) Install audio control switch (1) to steering wheel
(2).
2) Check that vehicle’s front tires are at straight-ahead
position and contact coil is centered. Refer to
“Centering Contact Coil”.
CAUTION
!
These two conditions are prerequisite for
installation of steering wheel. If steering
wheel has been installed without these
conditions, contact coil will break when
steering wheel is turned.
3) When installing new steering wheel, place match
mark at the same position of new steering wheel as
that of removed steering wheel.
4) Install steering wheel (1) to steering shaft with 3 lugs
(2) on contact coil fitted in three grooves (3) in the
back of steering wheel and also aligning marks (4)
on steering wheel and steering shaft.
I2RH01620009-01
I2RH01620010-01
1
2
3, (a)
I3RH0A620003-01
2
1
I3RH0A620004-01
I2RH01620011-01