Suzuki Liana RH413, Service Manual

Page: 487 / 1302

Front Brakes: 4B-3
4) Install wheel and lower lift.
5) Tighten wheel nuts to specified torque.
Tightening torque
Wheel nut (a): 85 N·m (8.5 kgf-m, 61.5 lb-ft)
6) After completion of installation, check for brake
effectiveness.
Front Disc Brake Pad Inspection
S3RH0A4206004
Check pad lining for wear. When wear exceeds limit,
replace with new one.
CAUTION
!
Never polish pad lining with sandpaper. If
lining is polished with sandpaper, hard
particles of sandpaper will be deposited in
lining and may damage disc. When pad lining
requires correction, replace it with a new one.
Brake pad thickness (lining thickness)
Standard: 10 mm (0.40 in.)
Limit: 2 mm (0.08 in.)
NOTE
When pads are removed, visually inspect
caliper for brake fluid leak. Correct leaky
point, if any.
Front Disc Brake Caliper Removal and
Installation
S3RH0A4206005
Removal
1) Hoist vehicle and remove wheel.
2) Loosen flexible hose joint bolt (1) a little at caliper.
CAUTION
!
Be careful not to twist flexible hose while
loosening the bolt.
3) Remove caliper pin bolts (1).
4) Remove caliper from caliper carrier.
5) Disconnect flexible hose from caliper using care not
to twist it. As this will allow brake fluid to flow out of
flexible hose, have a container ready beforehand.
Installation
1) Apply grease to slide pin, then install caliper to
caliper carrier.
2) Torque caliper pin bolts (1) to specification.
NOTE
Make sure that boots are fit into groove
securely.
Tightening torque
Caliper pin bolt (a): 22 N·m (2.2 kgf-m, 16.0 lb-ft)
for NISSIN made caliper
Caliper pin bolt (a): 35 N·m (3.5 kgf-m, 25.5 lb-ft)
for other than NISSIN made caliper
I2RH01420008-01
I2RH01420005-01
I2RH01420009-01
1
I2RH01420010-01