Suzuki Liana RH413, Service Manual

Page: 801 / 1302

Power Assisted Steering System: 6C-10
4) To facilitate adjustment after installation, put a mark
(2) on tie-rod thread indicating position of tie-rod end
lock nut (3). Then loosen lock nut and remove tie-rod
end (4) from tie-rod (1).
Installation
1) Install tie-rod end lock nut (3) and tie-rod end (4) to
tie-rod (1). Then, tighten lock nut to mark (2) on tie-
rod thread.
2) Install tie-rod end to knuckle (5). Then, tighten castle
nut (6) till holes for split pin (7) are aligned but within
specified torque range.
Tightening torque
Tie-rod end castle nut ((a)): 45 N·m (4.5 kgf-m,
32.5 lb-ft)
3) Bend new split pin (7) as shown in the figure.
4) After installing wheels, lower vehicle and tighten
wheel nuts to specified torque.
Tightening torque
Wheel nut (a): 85 N·m (8.5 kgf-m, 61.5 lb-ft)
5) Check that proper amount of toe-in is obtained
referring to “Front Wheel Alignment Inspection and
Adjustment in Section 2B”.
6) After confirming proper amount of toe-in, tighten tie-
rod end lock nut to specified torque.
Tightening torque
Tie-rod end lock nut (b): 45 N·m (4.5 kgf-m, 32.5
lb-ft)
Tie-Rod End Ball Joint Inspection
S3RH0A6306010
Inspect for play in tie-rod end ball joint (1). If found to be
defective, replace.
I2RH01630017-01
I2RH01630019-01
I2RH01630020-01
I2RH01630021-01
I2RH01630022-01
I2RH01630018-01