Suzuki Liana RH413, Service Manual

Page: 514 / 1302

4E-12 ABS:
DTC Check
S3RH0A4504004
Using ABS Warning Lamp
1) Perform “ABS Warning Lamp Check”.
2) Using service wire (4), connect diagnosis switch terminal (2) of monitor connector (blue) (1) to ground (3).
3) Turn ignition switch to ON position.
4) Read flashing of ABS warning lamp which represents DTC as shown in the following example and write it down.
When more than 2 DTCs are stored in memory, flashing for each DTC is repeated three times starting with the
smallest DTC number in increasing order.
For details of DTC, refer to “DTC Table”.
If DTC is not indicated at ABS warning lamp, go to “Code (DTC) Is Not Outputted Even with Diagnosis Switch
Terminal Connected to Ground”.
Example: When right-front wheel speed sensor circuit opens (DTC 21)
5) After completing the check, turn ignition switch off, disconnect service wire from monitor coupler.
Using SUZUKI Scan Tool
1) Turn ignition switch to OFF position.
2) Connect SUZUKI scan tool to data link connector
(1).
Special tool
(A): SUZUKI scan tool
I2RH01450004-01
I3RH0A450002-01
[A]: ABS warning lamp turned ON
[B]: ABS warning lamp turned OFF
[C]: Unit (Seconds)
(A)
1
I3RH0A450013-01