Suzuki Liana RH413, Service Manual

Page: 354 / 1302

2B-12 Front Suspension:
7) Pull out wheel hub (1) with special tools.
Special tool
(A): 09943-17912
(B): 09942-15511
CAUTION
!
When wheel hub is removed, replace wheel
bearing with new one.
8) Disconnect tie-rod end (1) from steering knuckle (2)
with special tool.
Special tool
(A): 09913-65210
9) Remove wheel speed sensor (1) from knuckle (if
equipped with ABS).
10) Loosen strut bracket nuts (1).
11) Remove ball joint bolt (3) and nut (4).
12) Remove strut bracket bolts from strut bracket and
then steering knuckle (2).
Installation
For installation, reverse removal procedure, noting the
following instructions.
• Using special tool, drive wheel hub (1) into steering
knuckle (2) and then install steering knuckle (2) to
strut and lower ball joint.
Special tool
(A): 09913-75520
CAUTION
!
Replace wheel bearing with new one
whenever the wheel hub has been removed.
• Install ball joint bolt (1) and nut (2) from the direction
as shown.
• Tighten suspension arm ball joint nut (2) to specified
torque.
Tightening torque
Suspension arm ball joint nut (a): 60 N·m (6.0 kgf-
m, 43.5 lb-ft)
I2RH01220028-01
I2RH01220029-01
I2RH01220030-01
F: Forward
R: Rearward
I2RH01220031-01
I4RH01220012-01