Suzuki Liana RH413, Service Manual

Page: 128 / 1302

1A-77 Engine General Information and Diagnosis:
DTC Troubleshooting
Step Action Yes No
1 Was “Engine and Emission Control System Check”
performed? Go to Step 2. Go to “Engine and
Emission Control
System Check”.
2 Check knock sensor signal
1) With engine running, check voltage from “C41-25”
terminal of ECM connector to body ground.
Is voltage about 1.23 – 3.91 V?
Intermittent trouble or
faulty ECM. Recheck,
referring to “Intermittent
and Poor Connection
Inspection in Section
00”. Go to Step 3.
3 Check knock sensor output
1) Stop engine.
2) With ignition switch at OFF position, disconnect knock
sensor connector.
3) With ignition switch at ON position, check voltage from
“RED” terminal of knock sensor connector to body
ground.
Is it 4 – 5 V?
Faulty knock sensor.
Substitute a known-
good knock sensor and
recheck. “RED” wire open,
shorted to ground circuit
or poor “C41-25”
connection.
If wire and connection
are OK, substitute a
known-good ECM and
recheck.
I2RH0B110045-01
I2RH01110089-01