Suzuki Liana RH413, Service Manual

Page: 1001 / 1302

Air Bag System: 8B-76
DTC B1071: Internal SDM Fault
S3RH0A8204031
DTC Will Set when
An internal SDM fault is detected by SDM.
NOTE
Before executing items in this flow, be sure
to perform “Air Bag Diagnostic System
Check”.
NOTE
DTC B1071 can never be cleared once it has
been set.
DTC Troubleshooting
1) Ignition switch OFF.
2) Replace SDM.
3) Repeat “Air Bag Diagnostic System Check”.
DTC B1072 / B1074: Internal Side Sensor (Driver
/ Passenger Side) Fault
S3RH0A8204037
DTC Will Set when
SDM receive internal fault signal from side sensor.
NOTE
Before executing items in this flow, be sure
to perform “Air Bag Diagnostic System
Check”.
DTC Troubleshooting
1) Ignition switch OFF.
2) Replace side sensor.
3) Repeat “Air Bag Diagnostic System Check”.
DTC B1073 / B1075 Side Sensor (Driver / Passenger Side) Correspondence Abnormality
S3RH0A8204038
Wiring Diagram
CAUTION
!
• Be sure to perform “Air Bag Diagnostic System Check” before starting diagnosis according to flow
table.
• When measurement of resistance or voltage is required in this table, use a specified digital
multimeter (Refer to “Special Tool”.) along with a correct terminal adapter from special tool
(Connector test adapter kit).
• When a check for proper connection is required, refer to “Inspection of Intermittents and Poor
Connections”.
• If there is open circuit in the air bag wire harness, connector or terminal is found damaged, replace
the wire harness, connector and terminal as an assembly.
1
2
RED GRN
RED
3
7
BLK
“L70”
L70-32
L70-31
4
“G14”
“L80”
“L77”
“L78”
5
GRN/WHT
GRN/BLK
L70-17
L70-6
6
LT GRN/BLK
LT GRN
L70-16
L70-5
I3RH0A820034-02
1. From main fuse 4. SDM 7. Ground for air bag system
2. Ignition switch 5. Side sensor (driver side)
3. “AIR BAG” fuse 6. Side sensor (passenger side)