Suzuki Liana RH413, Service Manual

Page: 330 / 1302

1J-8 Charging System:
Generator Components
S3RH0A1A06006
Generator Inspection
S3RH0A1A06007
Rotor
1) Using an ohmmeter, check for continuity between
slip rings of rotor. If there is no continuity, replace the
rotor.
Standard resistance between slip rings of rotor
2.7 – 3.1
Ω
at 20
°
C (68
°
F)
2) Using an ohmmeter, check that there is no continuity
between slip ring and rotor. If there is continuity,
replace the rotor.
3) Check slip rings for roughness or scoring. If rough or
scored, replace the rotor.
Using a vernier caliper, measure the slip ring
diameter. If the diameter is less than minimum,
replace the rotor.
Slip ring diameter
Standard: 14.2 – 14.4 mm (0.560 – 0.566in.)
Limit: 12.8 mm (0.503 in.)
I2RH0B1A0008-01
1. Pulley nut 6. Drive end bearing 11. Wave washer 16. Regulator 21. Terminal plate
2. Pulley 7. Bearing retainer 12. Rear end frame 17. Brush : Tightening torque
3. Drive end frame 8. Rotor 13. Seal plate 18. Brush holder
4. Stator 9. End housing bearing 14. Rectifier 19. Brush holder cover
5. Stud bolt 10. Bearing cover 15. Insulator 20. Rear end cover
IYSQ011A0042-01
IYSQ011A0043-01