Suzuki Liana RH413, Service Manual

Page: 36 / 1302

0B-4 Maintenance and Lubrication:
Drive Belt Replacement
S3RH0A0206036
WARNING
!
Be sure to disconnect negative cable from
battery before checking, adjusting and
replacing belt.
Water Pump and Generator Drive Belt
Replace belt with new one referring to “Water Pump /
Generator Drive Belt Removal and Installation in Section
1F”.
A/C Compressor and/or Power Steering Pump Drive
Belt
Replace belt with new one referring to “P/S Pump Drive
Belt Removal and Installation in Section 6C”.
Valve Lash (Clearance) Inspection
S3RH0A0206035
Inspect intake and exhaust valve lash and adjust as
necessary.
Refer to “Valve Lash (Clearance) Inspection in Section
1D” for valve lash inspection and adjustment procedure.
Engine Oil and Filter Change
S3RH0A0206002
WARNING
!
• New and used engine oil can be
hazardous.
Be sure to read “WARNING” in “General
Precautions in Section 00” and observe
what is written there.
• Step 1) – 7) outlined below must be
performed with ENGINE NOT RUNNING.
For Step 8), be sure to have adequate
ventilation while engine is running.
Before draining engine oil, check engine for oil leakage.
If any evidence of leakage is found, make sure to correct
defective part before proceeding to the following work.
1) Drain engine oil by removing drain plug.
2) After draining oil, wipe drain plug clean. Reinstall
drain plug, and tighten it securely as specified in the
following.
Tightening torque
Engine oil drain plug (a): 50 N·m (5.0 kgf-m, 36.5
lb-ft)
3) Loosen oil filter by using oil filter wrench (special
tool).
Special tool
(A): 09915–47331
NOTE
Before fitting new oil filter, be sure to oil its
O-ring. Use engine oil for this purpose.
1. Camshaft
2. Thickness gauge
I2RH0B020003-02
I2RH0B020004-01
I2RH0B020005-01
IYSQ01020009-01