Suzuki Liana RH413, Service Manual

Page: 402 / 1302

3A-3 Drive Shaft / Axle: Front
Drive Shaft Boot On-Vehicle Inspection
S3RH0A3116004
Inspect drive shaft boot for tear. If even a small tear is
noted, replace with new one.
Front Drive Shaft Assembly Removal and
Installation
S3RH0A3116002
Removal
1) Undo caulking (“A”) and remove drive shaft nut (1)
and washer.
2) Hoist vehicle.
3) Remove wheel.
4) Remove engine under covers.
5) Drain transaxle oil referring to “Manual Transaxle Oil
Change in Section 5B” for M/T model, “A/T Fluid
Change in Section 5A” for A/T model.
6) Drain transfer oil (4WD model) referring to “Transfer
Oil Change in Section 3C”.
7) Remove tie-rod end split pin (1) and castle nut (2).
8) Disconnect tie-rod end (3) from steering knuckle (4)
by using special tool.
Special tool
(A): 09913-65210
9) Pull out drive shaft joint (2) as follows.
• For vehicle without center shaft
Using tire lever (1), pull out drive shaft joint (2) so
as to release snap ring fitting of joint spline at
differential side.
• For vehicle with center shaft
Using plastic hammer (3), drive out drive shaft
joint (2) so as to release snap ring fitting of joint
spline at center shaft.
10) Disconnect front suspension control arm ball stud (1)
from steering knuckle (2) after removing ball stud
bolt (3) and nut.
9. Differential side joint (LH of M/T model)
: Apply light black grease included in spare part to joint.
: Do not reuse.
10. Damper (2WD A/T model and LH of 4WD A/T model)
I2RH01310001-01
I2RH01310003-01
[A]: For vehicle without center shaft
[B]: For vehicle with center shaft
I2RH01310004-01
I3RH0A311002-01
2
3
1
I2RH01310006-01