Suzuki Liana RH413, Service Manual

Page: 699 / 1302

Automatic Transmission/Transaxle: 5A-151
59) Install oil pump assembly to transaxle case.
Tightening torque
Oil pump assembly bolt (a): 25 N·m (2.5 kgf-m,
18.0 lb-ft)
60) Make sure that input shaft (1) turns smoothly.
61) Measure input shaft thrust play.
Apply dial gauge onto input shaft end (1) and
measure thrust play of input shaft.
Special tool
(A): 09900–20607
(B): 09900–20701
Input shaft thrust play
0.3 – 0.9 mm (0.012 – 0.035 in.)
62) After applying A/T fluid to new O-ring, fit it to
breather union (2). Then install breather union to
transaxle case.
63) Install breather hose (1).
64) Wipe off and clean mating surface between
transaxle case (1) and torque converter housing.
65) Apply sealant to torque converter housing (1) by
using a nozzle (2) as shown in the figure by such
amount that its section is 1.2 mm (0.047 in.) in
diameter.
“A”: Sealant 99000–31230
66) Install torque converter housing (1) to transaxle
case, tighten bolts to specified torque.
CAUTION
!
Apply sealant to threads of four bolts shown
in the figure before tightening.
“A”: Sealant 99000–31230
Tightening torque
Torque converter housing bolt (a): 33 N·m (3.3
kgf-m, 24.0 lb-ft)
67) Install harness bracket (2) to location shown in the
figure and tighten nut (3).
Tightening torque
Harness bracket nut (b): 10 N·m (1.0 kgf-m, 7.5
lb-ft)
I2RH0B510311-01
I2RH0B510312-01
I2RH0B510313-01
I2RH0B510314-01
1
2
“A”
I2RH0B510315-01