Suzuki Liana RH413, Service Manual

Page: 408 / 1302

3A-9 Drive Shaft / Axle: Front
1) Wash disassembled parts (except boots). After
washing, dry parts completely by blowing air.
2) Apply grease to wheel side joint. Use specified
grease in tube included in wheel side boot set.
3) Install wheel side boot on shaft, fill up boot inside
with grease, and then fasten boot with bands (1).
CAUTION
!
• Bend each boot band against forward
rotation (A).
• Do not squeeze or distort boot when
fastening it with bands. Distorted boot
caused by squeezing air may reduce its
durability.
4) Install damper (1) on left drive shaft according to
dimension specified as follows.
Drive shaft damper installing position (distance
“a” between reference position and damper)
Left side drive shaft for 2WD model: 187 – 193
mm (7.4 – 7.6 in.)
Left side drive shaft for 4WD model: 191 – 197
mm (7.5 – 7.7 in.)
5) Set new differential side small band and new
differential side boot on shaft temporarily.
6) Drive in the cage (1) by using a pipe (2).
CAUTION
!
Install cage directing smaller outside
diameter side to wheel side.
Drive shaft joint cage installing pipe diameter
“a”: 23.0 mm (0.906 in.) or more
“b”: 32.0 mm (1.260 in.) or less
7) Install circlip (1) by using special tool.
Special tool
(A): 09900-06107
I2RH01310032-01
I4RH01311009-01
I2RH01310034-01
I2RH01310035-01