Suzuki Liana RH413, Service Manual

Page: 831 / 1302

Heater and Ventilation: 7A-13
Repair Instructions
Blower Unit Components
S3RH0A7106001
Blower Unit Removal and Installation
S3RH0A7106002
Removal
1) Set air intake switch to fresh air mode with ignition
switch on, and then turn off ignition switch after three
seconds. (It takes about three seconds to move over
air intake selector door to fresh air position.)
2) Disconnect negative (–) cable at battery.
3) Remove glove box.
4) Remove instrument panel passenger lower member
(1).
5) Disconnect main harness connector (1) and clamp,
air intake control actuator connector (2) and blower
motor connector (3).
6) Remove blower motor relay (4) from blower unit.
7) Remove blower unit (1) from vehicle body.
Installation
Reverse removal procedure to install blower unit noting
the following instruction.
• When installing each part, be careful not to catch any
cable or wiring harness.
1
8
7
2
3
4
5
6
I3RH0A710009-01
1. Blower unit case 3. Air intake selector door 5. Air intake control actuator 7. Blower unit lower case
2. Blower motor assembly 4. Air intake selector link 6. Fresh air inlet duct 8. Blower motor relay
I3RH0A710027-01
1
4
3
2
I3RH0A710010-01
1
I3RH0A710028-01