Suzuki Liana RH413, Service Manual

Page: 450 / 1302

3C-17 Transfer:
Specifications
Tightening Torque Specifications
S3RH0A3307001
NOTE
The specified tightening torque is also described in the following.
“Transfer Assembly Components”
Reference:
For the tightening torque of fastener not specified in this section, refer to “Fasteners Information in Section 0A”.
Fastening part
Tightening torque
Note
N
⋅
m kgf-m lb-ft
Transfer oil drain plug 23 2.3 17.0
)
Transfer oil level/filler plug 23 2.3 17.0
)
Engine rear mounting bracket nuts 25 2.5 18.0
)
Transfer mounting bolts 50 5.0 36.5
)
Transfer to engine stiffener bolts 50 5.0 36.5
)
Transfer to transaxle stiffener bolts 50 5.0 36.5 )
Propeller shaft No.1 bolts 23 2.3 17.0 )
Exhaust No.2 pipe to muffler bolts 43 4.3 31.5 )
Suspension frame bolts 90 9.0 65.0 )
Engine rear mounting nuts 45 4.5 32.5 )
Ball stud lock nuts 60 6.0 43.5 )
Exhaust No.2 pipe to No.1 pipe bolts 43 4.3 31.5 )
Exhaust No.1 pipe to exhaust manifold bolts 50 5.0 36.5 )
Wheel nuts 85 8.5 61.5 )
Transfer case bolt 23 2.3 17.0 )
Corrected starting torque “c” of reduction drive
gear
0.35 – 2.5 0.035 – 0.25 0.25 – 1.8
)
Adjuster plate bolt 12 1.2 9.0 )
Transfer output retainer No.1 bolt 50 5.0 36.5 )
Transfer output retainer No2. bolts 50 5.0 36.5 )
Oil protect plate bolts 12 1.2 9.0 )
Oil receiver bolt 12 1.2 9.0 )
Rotational torque of bevel pinion shaft (Bearing
preload)
0.50 – 1.50 0.05 – 0.15 0.35 – 1.10
)
Transfer output flange nut (reference) 90 – 150 9.0 – 15.0 65.0 – 108 )
Rotational torque of bevel pinion shaft (Bearing
preload)
0.5 – 1.50 0.05 – 0.15 0.35 – 1.10
)