Suzuki Liana RH413, Service Manual

Page: 971 / 1302

Air Bag System: 8B-46
NOTE
Upon completion of inspection and repair work, perform the following items.
• Reconnect all air bag system components, ensure all components are properly mounted.
• Clear diagnostic trouble codes (Refer to “DTC Clearance”), if any.
• Repeat “Air Bag Diagnostic System Check” to confirm that the trouble has been corrected.
DTC B1024: Driver Air Bag Initiator Circuit Short to Ground
S3RH0A8204020
Wiring Diagram
3 1) With ignition switch OFF, disconnect Special Tool (B)
and (C), then reconnect contact coil connector “L28”
located near the base of the steering column.
2) Remove driver air bag (inflator) module from steering
wheel referring to “Driver Air Bag (Inflator) Module
Removal and Installation”.
3) Check proper connection to driver air bag (inflator)
module at terminals in connector “L81”.
4) If OK, then connect Special Tool (B) and (C) to connector
“L81”.
Special tool
(A): 09932-76010
(B): 09932-75010
(C): 09932-78310
With ignition switch ON, does DTC B1022 still exist?
Ignition switch OFF.
Replace contact coil
assembly referring to
“Contact Coil and
Combination Switch
Assembly Removal and
Installation in Section
6B”. Ignition switch OFF.
Replace driver air bag
(inflator) module
referring to “Driver Air
Bag (Inflator) Module
Removal and
Installation”.
Step Action Yes No
"L81"
STEERING WHEEL
(B)
(D)
(A)
I3RH0A820026-01
1
2
RED GRN
RED
3
7
BLK
“L70”
L70-32
L70-31
4
“G14”
“L80”
GRN/RED
GRN
“L28”
“L81”
“L70”
6
[A]
+12V
5
L70-27
L70-26
I2RH01820026-01
[A]: Shorting bar 3. “AIR BAG” fuse 6. Driver air bag (inflator) module
1. From main fuse 4. SDM 7. Ground for air bag system
2. Ignition switch 5. Contact coil assembly