Suzuki Liana RH413, Service Manual

Page: 608 / 1302

5A-60 Automatic Transmission/Transaxle:
3 Check pressure control solenoid valve resistance
1) Turn ignition switch OFF.
2) Disconnect valve body harness connector (1, 2) on
transaxle.
3) Check for proper connection to solenoid at “GRY/RED”
and “GRY/BLK” circuits.
4) Check resistance of solenoid valve
Pressure control solenoid valve resistance
Between terminals of transaxle side valve body
harness connector: 5.0 – 5.6
Ω
at 20
°
C (68
°
F)
Between terminal of transaxle side valve body
harness connector and transaxle: Infinity
Is check results satisfactory?
Go to Step 4. Replace pressure
control solenoid valve or
lead wire.
4 Check pressure control solenoid valve circuit for
ground short
1) Connect valve body harness connector.
2) Check continuity between terminal “G08-11” of
disconnected harness side TCM connector and ground.
Is continuity indicated?
“GRY/RED” or “GRY/
BLK” circuit shorted to
ground. Go to Step 5.
5 Check pressure control solenoid valve circuit for open
1) Check resistance between terminals “G08-11” and “G08-
8” of disconnected harness side TCM connector.
Is it infinity?
“GRY/RED” or “GRY/
BLK” circuit open. Intermittent trouble or
faulty TCM.
Check for intermittent
referring to “Intermittent
and Poor Connection
Inspection in Section
00”.
If OK, substitute a
known-good TCM and
recheck.
Step Action Yes No
1
6 7 8 9 10
5 4 3
2
1
2
I2RH0B510025-01