Suzuki Liana RH413, Service Manual

Page: 541 / 1302

ABS: 4E-39
8) If measured voltage is not as specified, check
sensor, ring and their installation conditions.
Reference
When using oscilloscope for this check, check if peak-to-
peak voltage (1) meets specification and waveform is
complete.
Peak-to-peak voltage at 3/4 to 1 1/4 rotation per
second
150 mV or more at 32 – 53 Hz
Rear Wheel Speed Sensor Removal and
Installation
S3RH0A4506009
Removal
1) Disconnect negative cable from battery.
2) Remove quarter inner trim (1).
3) Turn over floor carpet.
4) Hoist vehicle.
5) Disconnect rear wheel speed sensor coupler (1).
6) Detach ABS wheel sensor wire harness (2).
NOTE
Do not detach clip of rear wheel speed
sensor connector from vehicle body unless
replacement is necessary.
7) Remove rear wheel speed sensor (3) from knuckle.
CAUTION
!
• Do not pull wire harness when removing
rear wheel speed sensor.
• Do not cause damage to surface of rear
wheel speed sensor and do not allow dust,
etc. to enter its installation hole.
[A]: For wagon model
[B]: For sedan model
I2RH01450050-01
1
1
[B]
[A]
I3RH0A450023-01
[A]: For 2WD vehicle
[B]: For 4WD vehicle
[A]
[B]
1
3
2
2
1
3
I3RH0A450024-01